iesposta
Vector Runner
Spelunking VeCaves
Posts: 45
|
Post by iesposta on Mar 19, 2019 1:13:25 GMT -5
Any info / guess as to what is bad with a Vectrex that turns on without display, without buzz, then after some minutes works and plays perfectly?
Also, do you think this is also what people describe as "works fine after warm up"?
Only thing I recall mentioned is the protection of the tube if there is no X Y signal. This is what I could be experiencing. I bought this years ago after buying a near new in box controller, realizing the "newer" controller was probably on the console, and then just buying the console. Very little use/wear overall on anything, just this delay.
|
|
|
Post by gauze on Mar 19, 2019 11:36:56 GMT -5
The power switch is often the cause for this I guess, you can clean it but I don't know exact details but I think it has to be opened and it can be difficult to get back together. Someone else will chime in I'm sure.
|
|
|
Post by limitzer0 on Mar 19, 2019 23:20:43 GMT -5
It was the switch for me. I sprayed DeoxIT Pro Gold contact cleaner in the switch and exercised it a few times. It has worked fine since. That was about 2 years ago.
|
|
iesposta
Vector Runner
Spelunking VeCaves
Posts: 45
|
Post by iesposta on Mar 28, 2019 21:28:56 GMT -5
Is it the switch if you don’t touch anything for a few minutes and then it starts? What in the switch needs to “warm up”?!
|
|
|
Post by Malban on Mar 29, 2019 3:11:34 GMT -5
The following link is to a (German) video of a guy repairing the switch.
(In German he also explains WHY it is the switch :-9 )
Knowledge of German is needed, if you want to understand what he says. But even without it - you see a "live" repair of the switch - what is necessary, how to dissmantle the vectrex and put it together and what you need to solder... Video is about 1h:
|
|
|
Post by limitzer0 on Mar 31, 2019 2:33:10 GMT -5
Is it the switch if you don’t touch anything for a few minutes and then it starts? What in the switch needs to “warm up”?! Having dirty or corroded contacts in the switch is like having a resistor in line with the power. This can lower the amperage which can lead to things not working properly. I can't say that it is your switch for sure but it is usually the culprit for the problem you describe.
|
|