|
|
Post by vectrexmad on Sept 19, 2020 18:02:21 GMT -5
the best is to use Gaffa tape. Apply on the corner edge and rub tape into edge. Then gently lift and pull towards you. You have to do this a good few times.
|
|
|
|
Post by vectrexmad on Sept 19, 2020 18:05:03 GMT -5
|
|
|
|
Post by TrekMD on Sept 19, 2020 23:45:16 GMT -5
Thank you. Ordered the tape from Amazon so I can take off the protector from the overlay.
|
|
|
|
Post by Malban on Sept 20, 2020 13:06:32 GMT -5
Vectorblade v1.03 available as binary download.
|
|
|
|
Post by TrekMD on Sept 22, 2020 18:37:51 GMT -5
the best is to use Gaffa tape. Apply on the corner edge and rub tape into edge. Then gently lift and pull towards you. You have to do this a good few times. Tape arrived today and it worked like a charm. Thank you! |
|
|
|
Post by pseudophysics on Oct 1, 2020 13:43:34 GMT -5
Vectorblade v1.03 available as binary download.
would it be possible to make the 4 file version work with a VecMulti card? I just tried this, but no luck |
|
|
|
Post by Mayhem on Oct 2, 2020 2:40:16 GMT -5
No, it will only work in VIDE, on VecFever, and maybe Vextreme in the future.
|
|
|
|
Post by pseudophysics on Oct 2, 2020 7:55:47 GMT -5
No, it will only work in VIDE, on VecFever, and maybe Vextreme in the future. dang… but thanks for clearing that up |
|
|
|
Post by Malban on Oct 2, 2020 10:15:15 GMT -5
Vectorblade source and ressources available on GitHub:
Cheers
Malban
|
|
|
|
Post by Mayhem on Oct 5, 2020 8:04:00 GMT -5
Packrat moving forward with its release, and sounds like it will be very similar to Malban's overall.
|
|
